To facilitate proper air circulation, the cooler should not be installed in any enclosed or confined space.

Prior to installation, remove back cover of cooler and visually inspect for transit damage. Temporarily connect cooler to electric supply and switch on the thermostat. Check that fan is operating and not jammed.

For installation, connect the water inlet and waste water drain connections. Do not use excessive force on the brass inlet and drain connectors of the cooler as this tends to damage it.

Connect 3-pin 15 ampere plug to the cooler's main power cable with the green or yellow wire connected to the earthing terminal of the plug.

Always use a proper circuit breaker to avoid compressor burnout.

Switch on the power and adjust thermostat to the desired temperature. At the coolest position, you will obtain water between temperature of 9° C to 15° C (depending on the temperature of the room and inlet water).